SIGMACOVER 620

SIGMAZINC 100

Two component polyamide cured zinc epoxy primer  

PRINCIPAL CHARACTERISTICS

• Designed as a system primer for various paint systems
• Good corrosion prevention properties
• Quick drying, can be overcoated after a short interval even if at low temperature
• Good low temperature drying the subsequent coat must be unsaponifiable

• Gray
• Flat

SIGMASHIELD 460

Two-component, high solids glass flake reinforced polyamine adduct epoxy   coating   PRINCIPAL CHARACTERISTICS

• Excellent abrasion and impact resistance
• Suitable for use on ice-going vessels
• Excellent resistance to corrosion
• Long-term protection at areas subject to heavy wear and tear
• Resistant to splash and spillage of a wide range of chemicals
• Very low water permeability, due to glass flake barrier

• Black (other (light) colors on request)
• Gloss

SIGMARINE 24

Modified zinc phosphate alkyd  primer   PRINCIPAL CHARACTERISTICS

• Economical, general-purpose maintenance and new-building primer
• Suitable for use on superstructures and on steel surfaces not normally exposed to water immersion
• The adhesion of subsequent coats is not affected by long weathering periods of the primer
• Should not be used over zinc primers, except when exposed to dry interior  conditions
• To be recoated with conventional paint systems
• A thickness of 75 µm (3.0 mils) can be obtained by spray application in one operation by means of the cross-coat   technique

• Yellow, brown, red, gray, dark gray (offwhite only on request)
• Flat

SIGMACOVER 435

Two-component, high-build, micaceous iron oxide-pigmented, polyamide-cured recoatable epoxy    coating   PRINCIPAL CHARACTERISTICS

• General-purpose epoxy buildcoat or finish in protective coating systems, for steel and concrete structures exposed to atmospheric land or marine conditions
• Easy application, both by airless spray and brush
• Cures even at temperatures down to -10°C (14°F)
• A high relative humidity (maximum 95%) during application and curing does not influence the quality of the  coating
• Good adhesion on most aged, sound alkyd, chlorinated rubber and epoxy  coatings
• Can be recoated with various two-component and conventional coatings, even after long weathering  periods
• Resistant to water and splash of mild chemicals
• Excellent durability
• Tough, with long-term flexibility
• Resistant to temperatures up to 200°C (390°F) (see SYSTEM SHEET 4062)

• Light gray (9553-05), dark gray ( 9558-05), green (9441-05), aluminum (9590-05)
• Eggshell