SIGMARINE 48

SIGMA VIKOTE 18

High-build, aluminum pigmented chlorinated rubber  primer/sealer   PRINCIPAL CHARACTERISTICS

• Anticorrosive primer/sealer
• Excellent water resistance
• Unsaponifiable
• Resistant to well designed/controlled cathodic protection
• Fast-drying
• Can be applied at low temperatures, down to –10°C (14°F)
• Tolerates a DFT up to 150 µm (6.0 mils) at overlaps without sagging
• Compatible with antifoulings

• Gray, reddish gray
• Flat

SIGMAZINC 9

Two-component, moisture-curing zinc (ethyl) silicate  coating  

PRINCIPAL CHARACTERISTICS

• Specified for structural joints according to ASTM A325 or A490 Bolts RCSC specification, Class B
• Complies with the compositional requirements of SSPC-Paint 20, Level 1
• Anticorrosive primer for structural steel
• Suitable as a system primer in various paint systems based on unsaponifiable binders
• Can withstand substrate temperatures from –90°C (–130°F) up to 400°C (750°F), under normal atmospheric exposure conditions
• When suitably topcoated provides excellent corrosion protection for steel substrates up to 540°C  (1000°F)
• Good low-temperature curing
• Good impact and abrasion resistance
• Must not be exposed to alkaline (more than pH 9) or acidic (less than pH 5.5) liquids

• Gray, greenish gray
• Flat

SIGMARINE 24

Modified zinc phosphate alkyd  primer   PRINCIPAL CHARACTERISTICS

• Economical, general-purpose maintenance and new-building primer
• Suitable for use on superstructures and on steel surfaces not normally exposed to water immersion
• The adhesion of subsequent coats is not affected by long weathering periods of the primer
• Should not be used over zinc primers, except when exposed to dry interior  conditions
• To be recoated with conventional paint systems
• A thickness of 75 µm (3.0 mils) can be obtained by spray application in one operation by means of the cross-coat   technique

• Yellow, brown, red, gray, dark gray (offwhite only on request)
• Flat

SIGMACOVER 435

Two-component, high-build, micaceous iron oxide-pigmented, polyamide-cured recoatable epoxy    coating   PRINCIPAL CHARACTERISTICS

• General-purpose epoxy buildcoat or finish in protective coating systems, for steel and concrete structures exposed to atmospheric land or marine conditions
• Easy application, both by airless spray and brush
• Cures even at temperatures down to -10°C (14°F)
• A high relative humidity (maximum 95%) during application and curing does not influence the quality of the  coating
• Good adhesion on most aged, sound alkyd, chlorinated rubber and epoxy  coatings
• Can be recoated with various two-component and conventional coatings, even after long weathering  periods
• Resistant to water and splash of mild chemicals
• Excellent durability
• Tough, with long-term flexibility
• Resistant to temperatures up to 200°C (390°F) (see SYSTEM SHEET 4062)

• Light gray (9553-05), dark gray ( 9558-05), green (9441-05), aluminum (9590-05)
• Eggshell